802.1X Commands
dot1x timeout supp-timeout
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
43
2
Parameters
•
seconds
—Number of seconds between reauthentication attempts. (Range:
30 to 65535)
Default Configuration
3600 seconds
Command Mode
Interface Configuration (Ethernet) mode
Example
switchxxxxxx(config)#
interface gi15
switchxxxxxx(config-if)#
dot1x timeout reauth-period 5000
dot1x timeout supp-timeout
To set the time interval during which the switch waits for a response to an
Extensible Authentication Protocol (EAP) request frame from the client before
resending the request, use the dot1x timeout supp-timeout Interface Configuration
(Ethernet) mode command.
To revert to its default setting, use the no form of this command.
Syntax
dot1x timeout supp-timeout
seconds
no dot1x timeout supp-timeout
Parameters
•
seconds
—The time interval in seconds during which the switch waits for a
response to an EAP request frame from the client before resending the
request. (Range: 1 to 65535 seconds)
Default Configuration
The default timeout period is 30 seconds.
