Circutor DHB-402, Инструкция по эксплуатации

Страница: 31 / 60

To modify the value of the selected digit, press the button repeatedly.
To jump to the next digit, press the button
Once at the desired value, validate by pressing the button.
You can now select the position of the decimal point, which will be flashing.
To select the position of the decimal point, press the button.
Validate by pressing the button. The unit goes back to the screen shown in
Figure 37
.
To move to the next parameter on the menu, press the button.
When the button is pressed, the unit goes to the main screen of the alarms menu (
Figure 33
).
Range : -19999 ... 99999.
Default value: 200.00
Note: PrL
>
PrH
will cause the alarm to be disabled.
4�7�4�5� CONNECTION AND DISCONNECTION DELAY
This screen is used to configure the connection and disconnection delay for the alarm.
The screen flashes between the symbol and the configured value (
Figure 38
).
Figure 38:Connection/disconnection delay screens�
To edit the parameter, press the button.
To modify the value of the selected digit, press the button repeatedly.
To jump to the next digit, press the button
Once at the desired value, validate by pressing the button.
To move to the next parameter on the menu, press the button.
When the button is pressed, the unit goes to the main screen of the alarms menu (
Figure 33
).
Range : 0 ... 32400 seconds.
Default value:
0
4�7�4�6� LEDs
These screens are used to activate the interlocking of the display LEDs that indicate whether an alarm
has been activated or not.
The screen flashes between the symbol and the configured value (
Figure 39
).
31
Instruction Manual
DHB-402 DHB-424