APPENDIX A: DISPLAY MESSAGES
The error screens shown in
may appear after the unit is switched on or while it is measuring
�
Table 15:Error messages
Error messages
Overflow of the measured value above its range. This message
may also indicate a break in the sensor circuit (Thermocouple or
RTD)
Underflow of the measured value below its range. This
message may also indicate a short-circuit in the sensor circuit
(Thermocouple or RTD)
Communication error with the data memory.
Contact Customer Service.
Parameter error.
Error in configuration data. The default configuration will be loaded
as soon as any button is pressed.
The default parameters have been loaded. To continue with the
job, press any button
Error storing the values measured by the unit (measured value,
maximum value, minimum value). Press any button to go back to
the unit's measuring job. After pressing it, the screen
ErdEF
will
be displayed for 1 second.
Error calibrating the analogue output. Press any button to go
back to the unit's measuring job. The analogue outputs are not
in service.
Contact Customer Service.
S
R
DHB-324
The calibration values have been lost. Contact Customer Service.
59
Instruction Manual
DHB-402 DHB-424
