Circutor DHB-402, Инструкция по эксплуатации

Страница: 30 / 60

To move to the next parameter on the menu, press the button.
When the button is pressed, the unit goes to the main screen of the alarms menu (
Figure 33
).
Default value : Manual deactivation of the alarm relay ( H-off ).
4�7�4�3� ALARM LOW VALUE
This screen is used to configure the low value of the alarm, PrL .
The screen flashes between the symbol and the configured value (
Figure 36
).
S
R
DHB-424
Figure 36:Alarm low value screen�
To edit the parameter, press the button.
To modify the value of the selected digit, press the button repeatedly.
To jump to the next digit, press the button
Once at the desired value, validate by pressing the button.
You can now select the position of the decimal point, which will be flashing.
To select the position of the decimal point, press the button.
Validate by pressing the button. The unit will go back to the screen shown in
Figure 36
.
To move to the next parameter on the menu, press the button.
When the button is pressed, the unit goes to the main screen of the alarms menu (
Figure 33
).
Range: -19999 ... 99999.
Default value:
100.00
Note:
PrL > PrH will cause the alarm to be disabled.
4�7�4�4� ALARM HIGH VALUE
This screen is used to configure the high value of the alarm, PrH .
The screen flashes between the symbol and the configured value, (
Figure 37
).
S
R
DHB-424
Figure 37:Alarm high value screens�
To edit the parameter, press the button.
30
DHB-402 DHB-424
Instruction Manual