Circutor Computer SMART III FAST 12, Инструкция по эксплуатации

Страница: 78 / 112

The key shows the next option.
The key shows the previous option.
Press to validate the data; the symbol disappears from the display.
Press the key to access the next programming step.
If no keys are pressed for 5 minutes, the unit switches to the simulation screen,
“5.30.- SIMULATION
SCREEN”
.
5�8�- PROGRAM
The unit is made up of stages with different powers. The base power (value 1) will be that of the stage
with the lowest power. The powers of all the other stages will depend on the power of the first stage.
Example:
Program 1�1�1�1 , all the stages have the same power as the first one.
Program 1�2�4�4
, the second stage has twice the power and the next ones have four times the power
of the first one. (
See “4.1.4 REGULATION PROGRAM”
)
When configuring the program, remember that the subsequent stage cannot be lower than the prior
stage, and that the first stage is always 1.
Also program the system that controls the connection sequence of the different stages, where:
FCP
, operation following the
FCP
(
“4.1.3 FCP SYSTEM (FAST COMPUTERIZED PROGRAM)”
)
TOTAL
, total operation where all the steps are connected or disconnected at the same time,
without following a sequence; This operation is faster than the
FCP
.
SIM , no operation, the unit stays in simulation mode
(12)
.
(12)
In SIM mode, the measurement screens simulate the outputs that the unit would connect or
disconnect, but it doesn't actually do so. To avoid confusion, on the measurement screens the name
of the screen is switched with the literal
M
o d e
SIM
.
Press the key to enter editing mode. It is identified by the symbol and the blinking of the
digits to be modified.
78
Computer SMART III FAST
Instruction Manual