5
Trailer Safety
Operating this machine requires workers to perform work behind the trailer, it is critical to perform
the work safely. Communication between the tow vehicle driver and worker is critical. Worker and
tow vehicle driver shall must stay in communication, use an audible device or visual signals to
communicate. A worker must never ride on the trailer or position him or herself between the tow
vehicle and trailer when the tow vehicle is running. Tow vehicle driver must always be aware of
workers position.
Only use a tow vehicle that is equipped with an electronic brake control system and has the
appropriate towing capacity
.
The best means for determining the vehicle's towing capacity is to
read the vehicle owner's manual. The owner's manual will provide detailed instructions and
limitations, usually accompanied by tips for safe towing.
If the owner's manual has been
misplaced, most manufacturers provide free downloadable copies on their website.
T
owing with an
undersized tow vehicle
can cause the trailer to tow improperly, potentially causing loss of control.
Overloading can also cause unintended failures to tow vehicle.
The weight of your trailer
listed in this manual is for the base model without any additional
accessories or the weight of the sealant. The weight of your trailer will vary, weigh your machine to
determining your Gross Vehicle Weight (GVW). Scales are sometimes available to use at state
highway weigh stations, refuse transfer stations and commercial truck stops.
Trailer Stabilizing Procedure
Going under the trailer puts a person at risk of severe injury or
death. Follow procedure below to stabilize trailer before going under the trailer
Method #1 Hitch to Vehicle.
Park both the tow vehicle and trailer on a flat level surface. Place tow vehicle in park and remove
keys.
Method #2 Unhitched.
Park trailer on a level surface. Place wheel blocks in front of and behind wheels on both sides of
the trailer. Inspect your swivel jack thoroughly for damage or abnormal wear, especially if it was
subjected to abnormal load or shock. [
If damaged do not use, replace swivel jack
.] Turn the swivel
jack to the vertical position and pin in place. Use the swivel jack to decouple trailer from tow
vehicle. After raising the hitch coupler, crib, block, or otherwise secure the trailer at once.
WARNING
Содержание C1
