26
Heat Transfer Oil Specifications
ISO Grade 68 Heat transfer Oil Specification
To insure maximum safety and performance, CIMLINE recommends you purchase your oil
through CIMLINE. CIMLINE Heat Transfer Oil can be ordered in bulk quantities and is also
included when ordering a CIMLINE Maintenance Kit. Contact your CIMLINE dealer to order.
There are many different types of Heat Transfer Oils on the international marketplace. It is
critical that you use the proper oil to prevent poor performance, oil flashing, or auto-ignition. To
conform to most government bids and to supply a readily available product, ISO Grade 68 Heat
Transfer Oil specifications listed.
Using Heat Transfer Oil that does not meet CIMLINE Heat Transfer Specification is cause
for a voided warranty
Reference information
ISO GRADE -
Is a viscosity index (ability to flow/thickness). An ISO Grade 68 oil can be an
engine oil, hydraulic oil, etc. The manufacturer uses different additives to make the oil conform to
different applications.
YOU MUST CLARIFY
with the supplier that the oil is to be used in a heat
transfer system to avoid any potential problems. Oil is also available from CIMLINE in 5 and 30
gallon(19 and 114L) containers for ship-out.
FLASH POINT -
Test in which an open container of oil is heated until an open flame will
flash when passed over the fumes.
FIRE POINT -
Same test as the flash point except the oil is heated until the gasses will start
a fire.
AUTO IGNITION POINT -
The point at which fumes will burst into flame when exposed to air.
NOTE: CIMLINE Melter/Applicators use an expansion tank, when the oil heats up and expands, it
flows into the expansion tank. The expansion tank is cooler since it is not oil jacketed and is
surrounded by outside airflow. The only exposure the hot oil has to the atmosphere is through a
3/4" vent/overflow pipe. This is done so the oil in the tank can run higher than the flash point.
Only the lower temperature oil fumes are exposed to the atmosphere.
Viscosity CsT @ 40C
62
ISO VG#
68
Pour Point
10º F (12º C)
Flash Point
485º F (252º C)
Density
7.27 lb/gal (4.22 kg/L)
NOTICE
Содержание C1
