Cima New Plus, Инструкция по обслуживанию, Страница: 59 / 96

Rev.00 - Jan. 2013
51
New Plus
42-45-50-55
10.5 END OF TREATMENT - STORAGE
10.5.1 Daily
The operator must:
if the machine is equipped with unit-washing tank:
a. carry out the hydraulic circuit washing process (see paragraph 10.4) spraying on the piece of ground
treated yet. Attention: to make to spray the sprayer for around 5 sec..
b. Wash the inside of the tank:
1. Disengage the fan (for the version where foreseen): see point 8.1.a.
2. Close the taps of the 2-way distributor:
- if electrical, position the latch switches (E10).on “OFF”
- if manual (P9), set the levers in the horizontal position;
3. Turn the tap lever (P6) in pos. “ B ” .
4. Open the cock (P15) and position the lever of tap (P2) to the “ D ” position.
5. Engage the drive outlet (PTO) and take it to a speed of 540 RPM
540
Use ONLY the PTO at 540 rpm. Engage the PTO with the engine of the tractor at
low speed and with maximum modularity, obtaining soft and progressive graft
and avoiding abrupt starts of the cardan shaft.
6. Open the tap (P12), lever on “ a ”.
7. Rinse the tank untill the water in the spray-line rinsing tank is totally run out, if needed wash the
internal of the tank with a jet of clean water as expected for the machine without circuit-washer.
8. Disengage the drive outlet (PTO).
9. Close the tap (P12), lever on “ c ”.
10. Close the cock (P15) and re-position the lever of tap (P2) to the “ A - WORK ” position.
11a. Discharge the rinsing water in area with a drain basin and arrange the waste following the
country rules.
01259
P6
P12
01278
01280