Cima New Plus, Инструкция по обслуживанию

Страница: 29 / 96

Rev.00 - Jan. 2013
21
New Plus
42-45-50-55
P16. T-FITTING WITH DISCHARGE PLUG
Connected to the suction pipe (T1) of the tank and fixed to the 3-way tap (P2), it allows to drain the tank..
WARNING: the tank contains PHYTOSANITARY PRODUCTS. Discharge in an area
equipped with catch basin and provide to draining in the scrupulous rispect of the
local regulations in force.
In the versions with circuit-washer it is possible also the drain of the sole circuit-washer tank through
the fitting (P16)..
P4. CENTRIFUGAL PUMP
Fixed to the left-hand side of the machine, it is connected to the tank through the pipeline (T1), to the
three-way faucet (P6) and to the hydraulic agitation system for the mixture. The pump is provided by
the suction side of a filter to prevent the accidental entry of foreign bodies in the pump body, such a
possibility does not constitute a hazard and can only cause damage to the impeller shown by a drop
in pressure reported by gauge.
THE PUMP MUST NEVER RUN DRY
The water must be always in the pump : ALWAYS check this point carefully at the start
up and during the functioning.
To avoid any damage to the pump:
-
At the first filling and at every next filling after the hydraulic circuit draining, fill the tank with an
appropriate quantity of water to fill the pump completely; to do so, remove the cap from the pump
body and allow water into the tank until it comes out of the pump’s filler; refit the cap on the filler.
- In order to control that the pump is not running dry, AFTER engaging the PTO, check that the
pressure gauge (P8) shows an operating pressure value above 0 (zero); otherwise, STOP THE
PTO IMMEDIATELY.
P6
P4
P7
01261
FILTER
PLUG