CIGWELD Transmig 165ST, Руководство по обслуживанию

Страница: 19 / 126

SERVICE MANUAL
Transmig 165
ST
Transmig 165
ST
SERVICE MANUAL
Transmig 165
ST
Transmig 165
ST
Manual 0-5442 2-3 INTRODUCTION
2.05 Description
The Cigweld Transmig 165ST is a self contained
single phase multi process welding inverter that is
capable of performing GMAW/FCAW (MIG), MMAW
(Stick) and GTAW (Lift TIG) welding processes. The
unit is equipped with an integrated wire feed unit,
voltage reduction device (VRD applicable in stick
mode only) and a host of other features in order to
fully satisfy the broad operating needs of the modern
welding professional. The unit is also fully compliant
to Australian Standard AS 60974.1 and IEC 60974.1.
The Transmig 165ST MIG provides excellent welding
performance across a broad range of applications
when used with the correct welding consumables
and procedures. The following instructions detail how
to correctly and safely set up the machine and give
guidelines on gaining the best efficiency and quality
from the Power Source. Please read these instructions
thoroughly before using the unit.
2.06 User Responsibility
This equipment will perform as per the information
contained herein when installed, operated, maintained
and repaired in accordance with the instructions
provided. This equipment must be checked periodically.
Defective equipment (including welding leads) should
not be used. Parts that are broken, missing, plainly
worn, distorted or contaminated, should be replaced
immediately. Should such repairs or replacements
become necessary, it is recommended that such
repairs be carried out by appropriately qualified
persons approved by CIGWELD. Advice in this regard
can be obtained by contacting an Accredited CIGWELD
Distributor.
This equipment or any of its parts should not be altered
from standard specification without prior written
approval of CIGWELD. The user of this equipment
shall have the sole responsibility for any malfunction
which results from improper use or unauthorized
modification from standard specification, faulty
maintenance, damage or improper repair by anyone
other than appropriately qualified persons approved
by CIGWELD.
2.07 Transporting Methods
This unit is equipped with a handle for carrying
purposes.
WARNING
ELECTRIC SHOCK can kill. DO NOT TOUCH
live electrical parts. Disconnect input
power conductors from de-energized
supply line before moving the welding
power source.
!
WARNING
FALLING EQUIPMENT can cause serious
personal injury and equipment damage.
Lift unit with handle on top of case.
Use handcart or similar device of adequate capacity.
If using a fork lift vehicle, place and secure unit on a
proper skid before transporting.
2.08 Packaged Items
Transmig 165ST Plant (Part No. W1005165)
• Transmig 165ST Inverter Power Source
• Tweco Fusion 150 MIG Torch, 3m
• Comet Professional Argon Regulator/Flowmeter
• Feed roll: 0.6/0.8mm V Groove (fitted)
• Contact Tip: 0.8mm (fitted)
• Work Clamp with 4m Lead
• Shielding Gas Hose (fitted)
• Operating Manual