Christie RPMSP-D132U, Руководство пользователя

Страница: 89 / 134

Section 4: Advanced Configuration and Controls
RPMSP-D132U & RPMSP-D180U User Manual User Manual 4-21
020-100245-03 Rev. 1 (11-2010)
4.14.2 Color Adjustment Procedure
After the Color Primary Settings are calibrated for the site (see Section 4.14.1 Preliminary Calibration ), use
the Color Adjustments by X,Y or Color Saturation menu to refine each projector’s fundamental colors. The hue
and intensity of each color must appear the same from one display to another. Once matched, you will have
created a single new shared range of colors or “color gamut” that all of your projectors can produce. This
palette—named User 1, 2, 3 or 4—can be applied or disabled for a source at any time throughout a bank of
adjacent displays, simplifying both the setup and maintenance of a “seamless” wall.
1. Set up and optimize all projector settings. You can ignore color temperature, since you will be redefining
color performance in this procedure, but do optimize each projector in every other aspect. Closely align all
screen edges.
2. Assign projector numbers to make communications easier. Use a wired keypad.
3. Use the same lamp mode for all projectors, and do the following:
• Set Select Color Adjustment to “Max Drives”
• Display a full white test pattern
• Adjust lamp power until adjacent white fields appear the same brightness.
4. Display the Color Adjustments by X,Y menus for all projectors. Each menu shows the x/y coordinates
defining the “Max Drives” color gamut for this projector. Take note of the values shown in one (any) of the
displays. See
Figure 4-20 Make note of a Set of ”Max Drives” X/Y Values . Or use the “Copy From”
function to copy them into a “User” gamut in one projector.
F
IGURE
4-20 M
AKE NOTE OF A
S
ET OF
”M
AX
D
RIVES
” X/Y V
ALUES
5. In each projector, select a “User” color adjustment (1-4) to enable Color Adjustments by X,Y changes. Then
enter your recorded x/y values into each menu, see Figure 4-21 Copy X/Y Values into All Projectors .