3-14
RPMX/RPMSP-D132U & RPMSP-D180U User Manual
020-100245-03 Rev. 1 (11-2010)
Section 3: Operation
F
IGURE
3-10 A
DDING
OR
D
ELETING
C
HARACTERS
To accept edits and leave the edit window, press
(Enter).
NOTES:
1) Press
at any time to cancel changes and return to the previously-defined text.
2) Once you enter the first digit, this digit replaces all old digits.
3) Pressing any non-numbered key will accept the number entered up to that point as the new value.
4) Press
to cancel editing of numerical values.
3.4
Using Inputs and Channels
NOTE:
See Section 2, Installation and Setup, for details on connecting sources to the projector.
The projector stores and automatically recalls up to 50 different channels (source setups) for a variety of inputs.
This memory feature allows you to define and use a wide variety of customized setups. Depending on what is
defined, each physical source connection (i.e., input at the projector) can have several different channels
associated with it.
3.4.1
Selecting an Input
or Channel
INPUT –
An input is a source physically connected at the projector.
describes the source signal according
to which
input slot
it is connected.
SWITCHING INPUTS –
Press the appropriate “direct” key —
,
,
,
,
to display from one of
the five inputs connected. The image will be displayed according to the following:
If it is the first time you have used the source/input
(or if you used the input but did not define a channel by
adjusting anything), the projector will recognize the new input signal based on its frequencies and polarities. It
will automatically display an image according to the signal default settings. In general, the image from the new
source will be as large as possible without losing its aspect ratio. This and other default image settings depend
on the incoming source.
If you used the source once before and changed a display parameter
such as contrast, V-Position, etc., then a
channel was automatically created and still exists in projector memory (see below). Using one of the
keys
will automatically recall this channel—and all its setup parameters—and update the display accordingly.
Exit
Exit
Input
Input 1
Input 2
Input 3
Input 4
Input 5
Input
Содержание RPMSP-D132U
