2-8
RPMX/RPMSP-D132U & RPMSP-D180U User Manual
020-100245-03 Rev. 1 (11-2010)
Section 2: Installation and Setup
Lifting and transporting the projector
Use the handles on either side of the light engine to lift the projector. Use a stable cart to transport the projector.
Mounting
Refer to the drawings provided for your specific projector model in
Appendix Section B Dimensions &
Mounting Information
for mounting hole locations and other technical information.
Mount the projector to a sturdy, flat surface that fits the entire projector.
Use all four mounting points to secure the projector to the surface. Refer to
Appendix Section B
Dimensions & Mounting Information.
Maintain an area of empty space around the projector, called a “stay out zone”, to allow for air
circulation and clearance for cable connections to the input panel. An insufficient stay out zone area can
cause the projector to overheat during operation and/or place undue stress on source connections.
Step 4 Connecting sources
All source connections are made to the input panel of the Electronics Module. Each input is labeled for easy
identification. Using the appropriate cables, connect your source. Refer to
Section 2.3 Connecting Sources
for
more details on connecting a specific source.
NOTE:
An optional input module can be installed at Input 5 if additional connections are required. Refer to
Appendix D Optional Input Modules
.
Step 5 Turning the projector on and selecting a source
A North American rated line cord is provided with this projector. For all other regions,
make sure that you are using a line cord, power plug and socket that meet the applicable rating
standards.
Do not use a damaged line cord.
Before powering on make sure the lamp changer lock screw is removed. Failure to remove this screw
can cause damage to the projector and the lamp changer assembly.
1. Plug an approved line cord into the projector’s AC receptacle, located on the electronics module. Plug the
3-pronged end of the line cord into a grounded AC outlet.
NOTE:
The outlet must be near the equipment and easily accessible. Use only the line cord provided with the
projector or a power cord of appropriate rating that complies with regional standards.
NOTE:
Do not use a line cord or AC supply not in the specified voltage and power range.
See section Section
7 Specifications
for projector power requirements.
2. Press
for two seconds to turn the projector on. As the projector begins initialization, an active pattern
of segments appears in the LED status display window. Commands will be ignored until “On” appears.
RPMX-D132U
For XGA (0.69:1 lens). TD = 0.69 x W + 336 mm
RPMSP-D132U
For SXGA+ (0.69:1 lens). TD = 0.69 x W + 336 mm
For SXGA+ (1.20:1 lens). TD = 1.2 x W + 311 mm
RPMSP-D180U
For SXGA+ (0.69:1 lens). TD = 0.69 x W + 336 mm
For SXGA+ (1.20:1 lens). TD = 1.2 x W + 311 mm
Содержание RPMSP-D132U
