Christie RPMSP-D132U, Руководство пользователя

Страница: 40 / 134

3-6 RPMX/RPMSP-D132U & RPMSP-D180U User Manual
020-100245-03 Rev. 1 (11-2010)
Section 3: Operation
• Power and OSD keys —are “press-and-hold” keys that do not function with a typical quick press-
and-release key press.
• Hold arrow keys down for continuous adjustment/movement in one direction. In serial networks, pause
briefly between adjustments to make sure that more distant projectors can keep up with the commands.
• If you press a key while the projector is still responding to the previous action, such as during power-up, the
second key press may not take effect.
Specific keypad commands are:
Power ON/OFF
There are 3 options to power the projector ON or OFF:
• Press for two seconds to toggle the projector ON/OFF state.
• Press followed immediately by (ON) or (OFF) to switch the projector ON or OFF.
• Press to toggle the present ON/OFF state.
NOTES:
1) After powering down, the lamp cooling fan remains on for approximately 1-2 minutes to cool the lamp.
2) Keep the projector OFF for a few minutes. Hot re-strikes of the lamp may reduce lamp life.
3) The projector enforces a 60 second wait between powering OFF and ON to allow the lamp to cool down.
You will see vertical scrolling bars across the status display during this wait period.
Test
Steps through the internal test patterns and the current input.
Press and then the and arrow keys to cycle in either direction through the test patterns.
Auto
Initiates an automated process that optimizes critical display parameters for the current source, see Table 3.2
What an Auto Setup Does . An Auto Setup can save time in perfecting a display and modifying the adjustments.
Table 3.2 What an Auto Setup Does
NOTE:
You must have an unlocked channel present to use Auto Setup.
OPTIMIZES SETS TO DEFAULT
Pixel Tracking Contrast
Pixel Phase Brightness
Size and Blanking Auto Input Level (off)
Vertical Stretch Detail (if video source)
Position Filter
Input Levels Luma Delay
OSD
Test
Test
Auto