3-2
Roadie HD+35K User Manual
020-100340-02 Rev. 1 (01-2010)
Section 3: Operation
3.1.2 Ballast Breaker/Power Switch (ON/OFF)
The breaker/power switch located on the lamp ballast serves two purposes:
1) It is a power switch for the Roadie HD+35K ballast.
2) It protects against over-current conditions of 50A or more.
The breaker/power switch must be in the ON position to enable normal Roadie HD+35K system power-up and
operation. If faulty or major excessive AC is detected, the breaker/power switch "trips" to OFF in order to
prevent damage. Try switching the breaker/power switch ON again. If the breaker/power switch continues to
trip OFF, this indicates a major fault, and the AC problem must be resolved. Possible causes might include
shorts, damage to lamp cables, or very excessive AC.
NOTE:
You must press
POWER
on the built-in keypad as the breaker/power switch does not power up the
projector or start the lamp.
The ballast's internal fan is the only indication whether or not the breaker/power switch is ON. Lights on the
ballast indicate only that the ballast is plugged in.
3.1.3 Control Panel (Rear of Projector)
The rear control panel includes the built-in keypad, IR sensor, 2-digit status/error code display window, and the
LCD status display, as described in
Table 3.1
.
Figure 3-2 Rear Control Panel
Table 3.1 Rear Projector Control Panel
Control Panel Area
Description
Built-In Keypad
Provides access to all software controls needed for working with the projector. For
more convenient functionality, you can use a remote, web browser, or a serial message-
based method of control.
IR Sensor
Sensors at the front and rear of the projector detect commands from the standard IR
remote.
Two-Digit Status/Error
Code Window
The code that displays in this window indicates the basic operational state of the
projector. Each code references its corresponding status/error message and displays it
in the
LCD Status Display
window. Refer to
3.15.1 System Warnings/Errors
for the
list of all possible codes and corresponding messages.
LCD Status Display
Full status and error messages appear in this window.
Input 1
BNC
Input 3
Video
Input 4
S-Vid
Input 5
Opt.1
Input 2
DVI
Input 6
Opt. 2
Focus
Zoom
Menu
Exit
Help
Lens
Shift
Auto
Setup
Shutter
Status info and error
messages appear here
Built-in Keypad
Status/Error Code Display
LCD Status Display Window
IR Sensor
On/Off
Содержание Roadie HD+35K
