Section 4: Maintenance
Roadie HD+35K User Manual
4-11
020-100340-02 Rev. 1 (01-2010)
3. Pull out lens and replace as described in
Section 2.4.1 Lens Installation
. Insert all the way back, following
UP
label on lens.
NOTE:
Ensure that the Zoom connector is fully engaged.
In the event a lens is dropped, the lens tether and clamp assembly may become
stressed, and therefore must be replaced before continuing its use. Failure to do so
could result in injury or death.
Lens calibration must be performed each time a new lens is inserted or after
performing manual lens mount adjustments. This is critical to the projector
functioning properly. Failure to do so could result in damage to the lens mount, the
projector, or the projection lens.
Make sure to secure with lens locking lever (
UP
position) and safety tether: Refer to
Figure 2-23
.
NOTES: 1)
Make sure the lens UP label faces up, otherwise boresight may need readjustment.
2)
Keep the lens
safety tether attached to the projector ‘s handle or FredFrame
™
for use with any lens ring clamp. This
cable MUST be used with a flown projector.
Содержание Roadie HD+35K
