Christie Roadie HD+35K, Руководство пользователя

Страница: 21 / 192

Section 2: Installation and Setup
Roadie HD+35K User Manual 2-5
020-100340-02 Rev. 1 (01-2010)
Figure 2-5 Setting Lamp Size
c. Use the
U
P
/D
OWN
A
RROWS
to select which lamp is currently installed. Make sure the lamp type is also
indicated on the lamp door label.
Once the Status Display shows the correct lamp type, the projector and lamp can be switched ON.
NOTE: Lamp size can also be changed in the
Service
menu (Service password required) if the projector is
running, but it will not take effect until the next power-up. Whenever possible, define the lamp size before
igniting the lamp
.
6. Switch the projector and lamp ON. Using either the built-in keypad or the standard IR remote, do one of
the following to switch the projector ON, and ignite the lamp:
• press and hold
P
OWER
for at least two seconds
• press
P
OWER and then press the
U
P or
D
OWN Arrow key (useful if you are unsure of the present state of
the projector)
• press
P
OWER
twice quickly to toggle from the projector’s present ON/OFF state
The main PROJ. STATUS light at the rear of the projector should be green when the projector is up-and-
running. For best results, let the projector warm up for about 5 minutes.
7. Select the source . Using either the IR remote or built-in keypad, press the appropriate Input key (1-6) to
display the image for the corresponding source connected as described in Step 3. The display will resize as
needed, producing an image as large as possible for the type of source present.
8. Adjust the Image . Adjust the more common image settings, such as Brightness, Contract, Gamma, etc.
using the keys directly on the standard IR remote.
You can also access the Menu system and adjust these and other image settings by pressing
M
ENU
on the
standard IR remote.
,DMT
Press “Menu” before power up.
Screen below displays lamp size.
1.
3.
Or standard Christie service password.
2.
D
Lamp Size
6000
Select installed lamp size:
2000
3000
4500
6000
on the
standard
IR remote
on built-in
keypad
or
HOW TO SET THE LAMP SIZE:
on the
standard
IR remote
or
Enter Lamp Password:
on built-in
keypad
D
(MOTSỻ (MOTSỻ (MOTSỻ (MOTSỻ
7
4 1 0