DPF-300
INSTRUCTION MANUAL
Page 3
2020.09
INTRODUCTION
CHP DPF
-
300 is a manual depaneling system designed to solve
depaneling needs for small and medium production volumes,
where a simple hand tool would entail excessive labor, but the
production volume does not justify the cost of an automated
depaneling system.
Among the features of the DPF-300 is the possibility to change the
milling cutter and the INTERCHANGEABLE GUIDE (patented)
quickly.
The INTERCHANGEABLE GUIDE assists the operator throughout
the PCB positioning and dragging phase and speeds up the process
leading up to isthmus (tab) cutting.
The special design of the INTERCHANGEABLE GUIDE avoids
damage to the assembly in case of incorrect insertion. Thanks to
its special shape, the assembly will be completely protected
against accidents, in full compliance with the current safety
standards.
The CHP DPF-300 is designed to mitigate any
stress, break-off
and tearing
of PCB fibers. Such phenomena often occur when
using blades or hand tools to separate the panels. As the
complexity and miniaturisation of the printed circuit boards
increases, these types of tools are less and less tolerated.
The CHP DPF-300 cuts the isthmus with the
precision of an
automatic machine
at a much lower cost.
The electric extraction system of the DPF-300, placed directly on
the INTERCHANGEABLE GUIDE, removes all the dust produced by
the cutter, keeping the work area clean in accordance with the
regulations.