
DPF-300
INSTRUCTION MANUAL
Page 13
2020.09
5. INSTALLING/REPLACING THE GUIDE AND THE BIT
Make sure that the system is disconnected from the power supply before
carrying out any maintenance or adjustment work.
Before using the machine, check the thickness of the isthmus to be cut and then install the interchangeable
guide and milling bit of the required size observing the steps below (Fig.9):
1.
Remove the metal suction tube from the guide (when changing a previously installed guide).
2.
Loosen the 2 fixing screws
(1)
securing the interchangeable guide.
3.
Pull out the interchangeable guide.
4.
Loosen the 2 fixing screws securing head
(2)
and remove it.
5.
Lock the spindle shaft using the 14mm wrench
(3)
included in the package.
6.
Loosen the clamp by turning the 17mm wrench
(4)
included in the package counterclockwise.
7.
Remove the milling bit and insert the new one;
Make sure the bit is fully inserted and tightened
.
8.
Perform the steps above in reverse making sure to align the reference marks that indicate the correct
orientation of the head.
ATTENTION:
the diameter of the cutter should
match
the thickness of the guide.
INTERCHANGEABLE
GUIDE
STAINLESS
STEEL
SUCTION PIPE
MILLING
BIT
Fig. 9
HEAD
REFERENCE
MARK
REFERENCE
MARK