Chevrolet 2002 Venture, Руководство пользователя

Страница: 203 / 486

2-95
Your vehicle’s engine should be turned off while
programming the transmitter. Follow these steps to
program up to three channels:
1. Decide which one of the three channels (one of the
HomeLink buttons) you want to program.
2. Press and hold the desired button on HomeLink
through Step 3.
3. When the HomeLink indicator light begins to blink
slowly (this may take up to 30 seconds), hold the
hand
-
held transmitter about 1 to 3 inches (3 to 8 cm)
away from HomeLink and then press and hold the
transmit button on the hand
-
held transmitter.
Continue to hold both buttons until the indicator
light on HomeLink begins to flash rapidly (this may
take up to 90 seconds).
If you have trouble programming HomeLink, make
sure that you have followed the directions exactly as
described and that the battery in the hand
-
held
transmitter is not weak. If you still cannot program it,
move the hand
-
held transmitter to the left or right or
forward or backward or flip it upside down. HomeLink
may not work with older garage door openers that do
not meet current Federal Consumer Safety Standards.
If you cannot program the transmitter after repeated
attempts, refer to “Training a Garage Door Opener with
a “Rolling Code” Feature” later in this section or contact
the manufacturer of HomeLink at 1
-
800
-
355
-
3515, or
on the internet at www.homelink.com.
Be sure to keep the original hand
-
held transmitter
in case you need to erase and reprogram the
HomeLink Transmitter.