Smart Dry Contact Switch 7 - Operating Instructions
9
Timer Management
A timer can be set when switching On and/or Off. It is also possible to define which event will start the timer. (for
example only the change on the output due to double clicks).
Reset to the factory settings
The device can be reset to the original factory settings with 6 consecutive clicks on the integrated button.
After the reset is completed, the device will reboot and a
RED
solid led is showed.
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
INFO:
If the reset is performed while the device is still part of a network, it notifies the other devices that it has
been removed
(Device Reset Locally Notification)
.
Firmware Update
The system supports over-the-air firmware updates that do not require the device to be removed from its location. The
firmware update can be activated from all certified controllers supporting version 2 of the Firmware Update function.
WARNING:
The system will be rebooted at the end of the firmware update procedure. It is advisable to carry out
the firmware update procedure only when necessary and following careful planning of the intervention.
Offline setup Mode
The device has a unique feature that allows to configure some parameters without using any user interface. This feature
enables the professional user to setup the main features of the device in the field even if the device is not included in a
Z-Wave
™
Network. When the device will be included in the network all these configuration parameters will be
maintained.
To enter in offline setup mode, operate 2 clicks on the integrated button.
When the device is in Offline setup mode the led becomes solid Blue and the following configurations are permitted:
1 click
Setup input type to toggle switch. Equivalent to set parameter n.1 to 2
2 clicks
Activate a switch Off timer of 10 minutes. Equivalent to set parameter n.30 to 15 and
parameter n.31 to 6000
3 clicks
Activate a switch Off timer of 5 minutes. Equivalent to set parameter n.30 to 15 and
parameter n.31 to 3000
After receiving the command the led blinks a number of times equal to the number of clicks recognized
6 clicks
Exit from Offline setup mode and return to normal operation
Hold down for 5 seconds
Reset all configuration parameters to their default value and return to normal
operation
After entering in Offline setup mode, the device returns to normal operation if no action on the switch is detected for
more than 20 Seconds.
