Check Point L-71, Руководство администратора

Страница: 118 / 124

Advanced Configuration
Check Point 1400 Appliances Centrally Managed Administration Guide R77.20.85 | 118
To upgrade using CLIsh commands:
These are the file names that you can use:
•
autoconf.clish
•
autoconf.
<MAC address>
.clish
<MAC address>
is the specified MAC address in this format:
XX-XX-XX-XX-XX
You can create multiple configuration files for Check Point Appliance gateways. The gateways run
both files or only one of them. First the
autoconf.clish
configuration file is loaded. If there is a
configuration file with the same MAC address as the gateway, that file is loaded second.
Use the
#
symbol to add comments to the configuration file.
Boot Loader
The Gaia Embedded Boot Menu shows during boot and is available if you press
Ctrl+C
while the
appliance boots if you have a console connection. The menu contains the available options.
1. Start in normal Mode
2. Start in debug Mode
3. Start in maintenance Mode
4. Restore to Factory Defaults (local)
5. Install/Update Image/Boot-Loader from Network
6. Restart Boot-Loader
7. Run Hardware diagnostics
8. Install DSL Firmware / Upload preset configuration file
Please enter your selection:
When you are in Boot Loader, all interfaces are down and you can only activate them for options
that require connectivity. At this point Check Point’s services are not active.
Options 1-3 start the appliance.
• Normal mode is the default boot mode for the appliance.
• Debug mode boot gives printouts of processes that are initialized during boot.
• Maintenance mode boots the machine and gives access only to the file system (network
interfaces, Check Point processes and the appliance’s services are down).
Note - During normal/debug boot, if there is an error and the appliance cannot boot properly, it
reverts to maintenance mode and the Power LED turns a constant red.
Options 4-5 are explained in the subsequent sections.
Option 6 restarts the appliance.
Option 8 installs new firmware for the DSL modem (supported in DSL models only) or uploads a
preset configuration file.