Chassisworks 7704, Руководство по установке

Страница: 14 / 106

When installing the lower A-arm pivot studs,
be careful not to damage the threads. Tap
the pivot stud into place with your hand.
If the hand method does not work, you can
use a plastic-tipped hammer to gently install
the pivot stud. It is best to move the pivot
stud a small amount at a time until the
threads make contact.
Do not put grease on the pivot bushings they
are self-lubricating.
Once the pivot studs are in place, use an
Allen T-wrench to tighten them. The pivot
studs should go in easily and should be
tightened until they are fully seated. This will
give the bushings the proper amount of
crush, and allow the lower A-arm to move
with a small amount of resistance.
917704 Page 13