)NSTALL THE 0ROTECTOR 3YSTEM
/04)/. # &,//2 ).34!,,!4)/.
5SE AN EXTENSION BRACKET NOT PROVIDED OR WOOD BLOCK TO RAISE THE SENSOR BRACKET IF
NEEDED
#AREFULLY MEASURE THE POSITION OF BOTH SENSOR BRACKETS SO THEY WILL BE THE SAME
DISTANCE FROM THE WALL AND UNOBSTRUCTED
!TTACH THE SENSOR BRACKETS TO THE FLOOR USING CONCRETE ANCHORS NOT PROVIDED
3LIDE THE CARRIAGE BOLT INTO THE SLOT ON EACH SENSOR
)NSERT THE BOLT THROUGH THE HOLE IN THE SENSOR BRACKET AND ATTACH WITH THE WING
NUT 4HE LENSES ON BOTH SENSORS SHOULD POINT TOWARD EACH OTHER -AKE SURE THE
LENS IS NOT OBSTRUCTED BY THE SENSOR BRACKET
Insid
e
Garage
Wa
ll
(Not provided)
1
2
Carriage Bolt
1/4"-20 x 1/2"
Wing Nut
1/4"-20
3
4
7IRE THE 3AFETY 2EVERSING 3ENSORS
02%7)2%$ ).34!,,!4)/.3
)F YOUR GARAGE ALREADY HAS WIRES INSTALLED FOR THE SAFETY
REVERSING SENSORS SEE PAGE
/04)/. ! ).34!,,!4)/. 7)4(/54 02%7)2).'
2UN THE WIRE FROM BOTH SENSORS TO THE GARAGE DOOR OPENER !TTACH THE WIRE TO THE
WALL AND CEILING WITH STAPLES
3TRIP INCH MM OF INSULATION FROM EACH SET OF WIRES 3EPARATE THE WIRES
4WIST THE WHITE WIRES TOGETHER 4WIST THE WHITEBLACK WIRES TOGETHER
)NSERT THE WHITE WIRES INTO THE WHITE TERMINAL ON THE GARAGE DOOR OPENER )NSERT
THE WHITEBLACK WIRES INTO THE GREY TERMINAL ON THE GARAGE DOOR OPENER 4O INSERT
OR REMOVE THE WIRES FROM THE TERMINAL PUSH IN THE TAB WITH A SCREWDRIVER TIP
1
2
3
Staple
7/16" (11 mm)
WHITE
WHITE
GREY
RED
