0OWER
#ONNECT 0OWER
4O PREVENT POSSIBLE 3%2)/53 ).*529 OR $%!4( FROM ELECTROCUTION OR FIRE
z
"E SURE POWER IS ./4 CONNECTED TO THE OPENER AND DISCONNECT POWER TO
CIRCUIT "%&/2% REMOVING COVER TO ESTABLISH PERMANENT WIRING CONNECTION
z
'ARAGE DOOR INSTALLATION AND WIRING -534 BE IN COMPLIANCE WITH !,, LOCAL
ELECTRICAL AND BUILDING CODES
z
.%6%2 USE AN EXTENSION CORD WIRE ADAPTER OR CHANGE PLUG IN !.9 WAY TO
MAKE IT FIT OUTLET "E SURE THE OPENER IS GROUNDED
4O AVOID INSTALLATION DIFFICULTIES DO NOT ACTIVATE THE GARAGE DOOR OPENER AT THIS
TIME
4O REDUCE THE RISK OF ELECTRIC SHOCK YOUR GARAGE DOOR OPENER HAS A GROUNDING TYPE PLUG
WITH A THIRD GROUNDING PIN 4HIS PLUG WILL ONLY FIT INTO A GROUNDING TYPE OUTLET )F THE PLUG
DOESNT FIT INTO YOUR OUTLET CONTACT A QUALIFIED ELECTRICIAN TO INSTALL THE PROPER OUTLET
4(%2% !2% 47/ /04)/.3 &/2 #/..%#4).'0/7%2
/04)/. ! 490)#!, 7)2).'
0LUG IN THE GARAGE DOOR OPENER INTO A GROUNDED OUTLET
$/ ./4 RUN GARAGE DOOR OPENER AT THIS TIME
TYPICAL WIRING
/04)/. " 0%2-!.%.4 7)2).'
)F PERMANENT WIRING IS REQUIRED BY YOUR LOCAL CODE REFER TO THE FOLLOWING
PROCEDURE 4O MAKE A PERMANENT CONNECTION THROUGH THE INCH HOLE IN THE TOP
OF THE MOTOR UNIT ACCORDING TO LOCAL CODE
2EMOVE THE MOTOR UNIT COVER SCREWS AND SET THE COVER ASIDE
2EMOVE THE ATTACHED PRONG CORD
#ONNECT THE BLACK LINE WIRE TO THE SCREW ON THE BRASS TERMINAL THE WHITE
NEUTRAL WIRE TO THE SCREW ON THE SILVER TERMINAL AND THE GROUND WIRE TO THE GREEN
GROUND SCREW
4HE OPENER MUST BE GROUNDED
2EINSTALL THE COVER
Ground Tab
Green
Ground
Screw
Ground
Wire
White Wire
PERMANENT WIRING
Black
Wire
Black
Wire
