)NSTALLATION
$ETERMINE THE (EADER "RACKET ,OCATION
4O PREVENT POSSIBLE 3%2)/53 ).*529 OR $%!4(
z
(EADER BRACKET -534 BE 2)')$,9 FASTENED TO STRUCTURAL SUPPORT ON HEADER
WALL OR CEILING OTHERWISE GARAGE DOOR MIGHT ./4 REVERSE WHEN REQUIRED $/
./4 INSTALL HEADER BRACKET OVER DRYWALL
z
#ONCRETE ANCHORS -534 BE USED IF MOUNTING HEADER BRACKET OR X INTO
MASONRY
z
.%6%2 TRY TO LOOSEN MOVE OR ADJUST GARAGE DOOR SPRINGS CABLES PULLEYS
BRACKETS OR THEIR HARDWARE !,, OF WHICH ARE UNDER %842%-% TENSION
z
!,7!93 CALL A TRAINED DOOR SYSTEMS TECHNICIAN IF GARAGE DOOR BINDS STICKS OR
IS OUT OF BALANCE !N UNBALANCED GARAGE DOOR MIGHT ./4 REVERSE WHEN
REQUIRED
z
$/ ./4 ENABLE THE 4IMERTO#LOSE FUNCTIONALITY IF OPERATING EITHER ONEPIECE OR
SWINGING GARAGE DOORS 4O BE ENABLED /.,9 WHEN OPERATING A SECTIONAL DOOR
#LOSE THE DOOR AND MARK THE INSIDE VERTICAL CENTERLINE OF THE GARAGE DOOR
%XTEND THE LINE ONTO THE HEADER WALL ABOVE THE DOOR 9OU CAN FASTEN THE HEADER BRACKET
WITHIN FEET M OF THE LEFT OR RIGHT OF THE DOOR CENTER ONLY IF A TORSION SPRING OR
CENTER BEARING PLATE IS IN THE WAY OR YOU CAN ATTACH IT TO THE CEILING WHEN CLEARANCE IS
MINIMAL )T MAY BE MOUNTED ON THE WALL UPSIDE DOWN IF NECESSARY TO GAIN APPROXIMATELY
Ñ CM )F YOU NEED TO INSTALL THE HEADER BRACKET ON A X ON WALL OR CEILING USE LAG
SCREWS NOT PROVIDED TO SECURELY FASTEN THE X TO STRUCTURAL SUPPORTS
/PEN YOUR DOOR TO THE HIGHEST POINT OF TRAVEL AS SHOWN $RAW AN INTERSECTING HORIZONTAL
LINE ON THE HEADER WALL Ñ CM ABOVE THE HIGH POINT 4HIS HEIGHT WILL PROVIDE TRAVEL
CLEARANCE FOR THE TOP EDGE OF THE DOOR
./4% )F THE TOTAL NUMBER OF INCHES EXCEEDS THE HEIGHT AVAILABLE IN YOUR GARAGE USE THE
MAXIMUM HEIGHT POSSIBLE OR REFER TO PAGE FOR CEILING INSTALLATION
Header Wall
Unfinished
Ceiling
Vertical Centerline
of Garage Door
2x4
2x4
Structural
Supports
Level
(Optional)
OPTIONAL
CEILING
MOUNT FOR
HEADER
BRACKET
Sectional door with curved track
Header Wall
Track
2" (5 cm)
Highest Point
of Travel
Door
