Challenge CHAMPION 305 TC, Инструкция и каталог запасных частей

Страница: 17 / 110

7.0 Operation
17
To install:
1. DISCONNECT THE POWER AND LOCK IT OUT! (See Power Lockout, page 5.)
2. Position the false clamp plate under the clamp, (Figure 7). The locator pegs are positioned to
the rear of the cutter and are set into holes in the bottom of the clamp.
Figure 7
3. With a 1/8" Allen wrench, back off the setscrews in front of the clamp and raise the plate up to
the bottom of the clamp. It may be necessary to bring the clamp down onto a stack of paper
with the foot pedal in order to access the far left setscrew. Raise the false clamp plate evenly
or it will have a tendency to bind. When the plate has been raised into position and is flush
with the bottom of the clamp, tighten the setscrews to hold the plate in position.
4. Make sure that all tools have been taken off the cutter table, reconnect the power, and turn
on the machine.
NOTE: The backgauge will not move to a position less than 2" (51 mm) when the false clamp plate is
installed in the clamp.
When the false clamp plate is not in use, store it on top of the cutter, with the locator pegs inserted
into the 3 holes in the top cover. There is a sensor inside one of these holes that detects when the
false clamp plate is on top of the machine, thereby informing the machine that the false clamp plate is
not installed in the clamp. This allows the backgauge to be positioned less than 2” (51 mm), which it
will not do when the false clamp plate is installed in the clamp.
Locator
pegs
Set
Screws
1/8” Allen
Wrench