CHAINTECH CT-9PJL, Руководство пользователя

Страница: 47 / 81

Chapter 3
2. USB 2.0 controller
This entry is for disable/enable EHCI controller only. This BIOS itself may/may
not have high speed USB support. If the BIOS has high speed USB support built in,
the support will automatically be turned on when high speed device were attached.
3. USB Keyboard Support
Select Enabled if your system uses an USB keyboard. If there is no USB keyboard,
select Disabled in this field.
4. USB Mouse Support
Select Enabled if your system uses an USB mouse. If there is no USB mouse,
select Disabled in this field.
5. CMedia Audio
By default is [ 6 Channels ].
6. Onbd 1394
Select Enabled if your system uses an on-board IEEE1394. If there is no on-board
IEEE1394, select Disabled in this field.
7. Onbd PCI Audio
Select Enabled if your system uses an on-board PCI Audio card. If there is no
on-board PCI Audio card, select Disabled in this field.
8. Realtek LAN
Select Enabled if your system uses an on-board Realtek Lan. If there is no
on-board Realtek Lan, select Disabled in this field.
Super IO Device:
This section provides information on setting the Super I/O devices. Press [ Enter ] to
enter the sub-menu, which contains the following items for some advanced controls:
1. Onboard FDC Controller:
In order to use it select as Enabled if your system has a floppy-disk controller
(FDC) installed on the system board. If you install an add-in FDC or the system
has no floppy drive, choose Disabled in this field.
2. Onboard Serial Port 1/2:
Select an address and corresponding interrupt for the first and second serial ports.
Available options are [
3F8/IRQ4 ], [ 2E8/IRQ3 ], [ 3E8/IRQ4 ], [ 2F8/IRQ3 ],
[ Disabled ], and [ Auto ].
3. UART Mode Select:
This function allows you to select an operating mode for the second serial port.
(Normal RS-232C serial port / IRDA / SCR / ASKIR 0.57-MB/sec infrared port).
41