CHAINTECH 7VIF3, Руководство пользователя

Страница: 32 / 54

Chapter 3
1. Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC) installed on the system
board and you wish to use it. If you install an add-in FDC or the system has no floppy
drive, select Disabled in this field.
2. Onboard Serial Port 1/2
Select an address and corresponding interrupt for the first and second serial ports.
Available options are [3F8/IRQ4], [2E8/IRQ3], [3E8/IRQ4], [2F8/IRQ3], [Disabled],
and [Auto].
3. UART Mode Select
This function allows you to select an operating mode for the second serial port. (Normal
RS-232C serial port / IRDA / SCR / ASKIR 0.57-MB/sec infrared port)
4. UR2 Duplex Mode
Available options: [ Half ] and [ Full ].
5. Onboard Parallel Port
Select a logical LPT port address and corresponding interrupt for the physical parallel
port.
6. Parallel Port Mode
Select an operating mode for the onboard parallel (printer) port. Select SPP unless you
are certain your hardware and software support one of the other available modes.
7. ECP Mode Use DMA
This item automatically specifies a DMA channel 1 or 3 for the parallel port when it is
set to [EPP] or [ECP+EPP] mode.
8. Game Port Address
This item disables or assigns the address of the Game port. Available options are
[Disable], [201] and [209].
9. Midi Port Address
This item disables or assigns the address of the Midi port. Available options are
[Disable], [300] and [330].
10. Midi Port IRQ
This item specifies an IRQ for the Midi port. Available options are [5] and [10].
Init Display First
This function allows users to choose AGP or PCI slot to initialize display.
CIR Port Address (7VIF4 only)
This item disables or assigns the address of the CIR port. Available options are [Disable],
[310] and [320].
28