CF MOTO CF125T-22A, Руководство по обслуживанию

Страница: 8 / 239

&)0272
The rubber parts shall be checked whether they are
aged upon disassembly, renew them in advance
when necessary. Besides, try not to make volatile
oil, grease etc attach on the rubber parts, for they are
not resistant to corrosion of gasoline or kerosene.
3URSHUVSHFLDOWRROVPXVWEHDSSOLHGWRWKH
RSHUDWLRQVZKLFKUHTXLUHVSHFLDOWRROV
7KHLQVLGHRURXWVLGHWUDFNRIEDOOEHDULQJVKDOOEHWXUQHGPDQXDOO\IRU
FRQILUPLQJWKHIOH[LELOLW\DQGVPRRWKQHVVRIWXUQLQJ
The parts that are loose axially or radially shall be renewed. The parts that are
unsmooth shall be washed with oil, and the parts that are not repaired after washing shall
be renewed (the dual-side dustproof type cannot be washed)
Press it into the machine or axis, and the bearing shall be renewed if the pressed part is
not tight enough.
Do not let the bearing race turn back when blowing the ball
bearing by compressed air after washing. If the bearing race
turns back, its high back turning speed will be beyond the limit
that may result in damage of bearing. The bearing shall be
lubricated with engine oil or grease before assembly.
The recommended lubricating grease must be ap-
plied or injected in the appointed positions.
When disassembling the pressed ball bearing, the
disassembled bearing must not be used again if the
balls are forced for disassembly.
The installation direction of single-sided dustproof bear-
ing shall be paid attention to upon disassembly.
The surface of open-type or dual-side dustproof
bearing that is with the sign of manufacturer, di-
mensions shall face outside upon installation.
The side with chamfer shall face the impact direc-
tion when installing the circlip. The circlip that is
loose already or without elasticity shall not be used
again. Rotate the circlip after assembly, for con-
firming that it is installed in the groove properly.
All manuals and user guides at all-guides.com