CF MOTO 150NK, Руководство пользователя, Страница: 44 / 67

4. When changing oil, place a container under the engine, remove the drain plug and unscrew the three
nuts to take out the oil filter cover, springs filter.
5. Clean the oil drain plug and oil filter cover after draining the oil. Replace the oil filter and inspect the oil
seal. If the oil seal is damaged, replace it with a new one. Install the oil filter, spring, oil seal and oil filter
cover.
6. Add approximate 1.2 L new engine oil from the fuel filler. If the oil filter is replaced at the same time,
1.25 L new engine oil will be required. Inspect for oil leakage and then install the oil filler plug.
Pic 16 Sparkplug
Spark clearance
0.8 ~0.9mm
7.3 Spark plug selection and replacement
[
Spark Plug Selection
]
Spark plug type
：
CR9EP
Always use CFMOTO original spark plugs.
[
Spark plug inspection and replacement
]
1. Spark plug change interval: every 6000 km.
2. Remove the ignition coil. Clean up the dirt around the spark plug and use a socket wrench to remove
the spark plug, use a wire brush to remove carbon deposit and dirt on the spark plug.
3. Inspect the spark plug for damage. Check if the electrode is burnt out and if the gasket washer is
damaged.
4. Use feeler gauge to inspect the spark plug gap. The specified spark plug gap is 0.8 mm~ 0.9 mm.
5. To install a spark plug: finger screw in the spark plug into the threads hole at first and then use the
spark plug socket wrench to tighten it.
- 4 3 -