page 15 of 30
8.
Application
To achieve optimum therapeutic success, please observe the following:
⚫
To keep reflection losses as small as possible, the skin must be free of grease
and the TESLA 21+ LASER SHOWER must be applied vertically to the skin
.
⚫
A general rule that applies to all treatments is the principle of gradually
increasing the dosage. Initial treatments should last no longer than 2 minutes.
⚫
Maximum treatment time per patient is 10 min. After 10 min. irradiation, the
unit turns off automatically.
⚫
When doing laser treatments are done in CW-Mode in quick succession (only
short pauses), rising temperature of the laser diodes take place. Reaching an
internal temperature of <55° the mode is switched automatically to multi-
frequency mode. The temperature symbol on the display will inform you (page
21)
⚫
During laser emission, mini fans will see to an improved removal of heat. The
fans shut off when the laser emission is terminated.
⚫
When doing continuous laser treatments in CW mode at maximum output, or
treatments close together, the internal temperature may increase above 60°C.
The device will then switch off automatically. This will be indicated in the display
by
“temperature
auto
off”.
The device can only be switched on again, after the
diodes were able to cool down.
⚫
Do not activate the unit until you are in the treatment position.
⚫
Move the
TESLA 21+ LASER SHOWER
slowly and evenly across the surface of
the skin. The distance to the skin should be only a few mm when doing it.
⚫
Apply ointments, lotions and creams only after a laser treatment.
