page 8 of 30
3.
Operation
3.1
Unlocking
Insert the key pin into the red connector at the bottom of the housing of the
TESLA 21+ LASER SHOWER
(● page 4, fig. 1
/7)
.
The adapter for the laser shower
or laser comb must be plugged in (● section 9, “Replacing the Adapters”,
page
15, resp. page 4, fig. 2/10+11).
Connect AC adapter with adapter plug
The power supply unit (AC adapter) and the TESLA 21+ LASER SHOWER are
connected with an intermediate plug. Should you wish to remove the power
supply unit from the TESLA 21+ LASER SHOWER, please proceed as follows:
⚫
Slightly push back the locking device (black sleeve)
at the plug and pull the two plugs apart. The arrows
indicate the right alignment.
⚫
If you reconnect the TESLA 21+ LASER SHOWER with the AC adapter,
make sure you observe the direction of the arrows on the plugs.
3.2
Connect AC Adapter to the power supply
Connect the AC adapter to the mains (100
–
240 V~). A correct connection is
indicated by a green control light on the AC adapter.
3.3
Initial settings after booting
After switching the Laser on, the output data of your laser system (wavelength
and max. output) are indicated in the second line.
The TESLA 21+ LASER SHOWER cannot be operated without the adapter.
Only a Centurion Systems power
s
upply unit AC/DC adapter type
FW7555M/12 which was shipped with the unit must be used.
Attention!
The plug-in connection is a push-pull locking system. Hold the plug-in
connection only by the sleeves with the arrows, as illustrated.
Never twist
the plugs or pull at the back ends of the plug.
