14
FIG. 10 – ASSEMBLING THE
BIT-SPACER UNIT
FIG. 9 – ASSEMBLING SPIRAL BITS
FIG. 11 – MANUAL SPINDLE
ROTATION
07
18
DPE
*
DPE
Bits PE ...
(e.g. PE70)
Bits PE ...
(e.g. PE 220)
APE ...
* use only for APE, not required for
APED
71
33
6.2.2)
Insert into the spindle shaft, the
DPE
spacer required to activate the coolant system.
If it is necessary to use an
APE...
adaptor the bit must first be fitted in the corresponding
APE
adaptor and locked with the appropriate grub screw, then the
DPE
spacer inserted.
Note: Adaptors type APED… (e.g. APED 135/165) do not require use of DPE spacer.
6.2.3)
Insert the bit-spacer unit in the spindle shaft so that the two engaging dogs on the bit
spigot line up with the grub screws.
Press the bit-spacer unit home againt the inner
seat of the spindle: this will enable the DPE spacer to open the coolant circuit
(see Fig. 10).
6.2.4)
Clamp the bit by fully tightening the two grub screws (18) using the 4 mm male hexagon key.
