CellarPro 2000VSi, Руководство пользователя

Страница: 22 / 37

22
V4.18
•
Switch Instructions
(1) Control Panel: Maintains desired cellar environment. Factory settings are optimized for peak
performance. Controller is described in detail in the following section.
(2) Evaporator Fan Speed Selector Switch (Low - High): The evaporator fan operates on 2 speed
settings: Low, and High. For optimum sound and energy efficiency, select the lowest fan speed that
will maintain the desired cellar temperature. High speed is recommended for initial cellar pull down
and extreme temperature conditions, and
is required for ducted installations.
(3) Condenser Fan Speed Selector Switch (Low - High): The condenser fan operates on 2 speed
settings: Low, and High. For optimum sound and energy efficiency, select the fan speed based on
the maximum fresh air intake temperature. Low fan speed is suitable up to 100°F fresh air intake,
and high fan speed up to 110°F. High speed is recommended for initial cellar pull down and extreme
temperature conditions, and
is required for ducted installations.
(4) Power Selector Switch (Front/Rear): The unit is powered by installing the provided plug cord
in the front or rear of the unit. To use the front receptacle, set switch to “Front” and plug in the
cord at the front right side of the unit. To us e the rear receptacle, set to “Rear” and plug in the cord
at the rear of the unit.
(5) Bottle Probe Jack (Bottle Probe): Plug in the remote bottle probe (sold separately) to control
the cellar by liquid temperature rather than air temperature inside the cellar. Disconnecting the
probe will automatically return the control to air temperature. When using a bottle probe, the
Temperature Differential will need to be adjusted to 1 degree as shown in the “Advanced
Operation” instructions below.
(6/7) Grounded Power Receptacle: One receptacle is located on the front right, and one on the
rear. Use the receptacle that is most convenient for the installation. Enable the receptacle by
setting the power location switch to “Front” or “Rear”.