CellarMate Wine Cellar Climate Control, Инструкция по установке, эксплуатации и обслуживанию

Страница: 20 / 42

CellarMate Manual Page 15
Recommended Insulated Flexible Ductwork Sizing Chart
Evaporator (cooling) Coil Condenser (heat rejection) Coil
Model # Return Air Supply Air Return Air Supply Air
Single Double Single Single Double
025 8” 8” 6” 8” 8” 6”
050 10” 10” 6” 10” 10” 6”
088 10” 10” 8” 10” 10” 8”
200 12” 12” 10” 12” 12” 10”
Notes: 1. The above sizes are internal diameter in inches
2. If a single supply is used out of the unit, but then splits into two ducts, use
the sizes indicated for “Double” after the split.
Avoid crimping the flexible ducts, which reduces air flow and causes erratic operation.
Be sure that all ducts and surfaces that are in contact with the air flow are insulated and have
a vapor barrier on the outside surface.
General Duct Recommendations
•
Support the flexible duct often to prevent sags or bends. (Place supports close
enough to prevent the flexible ducting from sagging or bending).
•
Stretch the duct to create a smooth interior and reduce air resistance. Rigid
ductwork is best.
•
Insert a metal elbow in the flexible duct at 90° bends to maintain form.
•
Use straight and short lengths of ductwork.
•
Review the Air Flow Illustration on page 8 for duct connection options.
•
Remove the panels or grilles from the openings where the ductwork will be
connected and save the screws.
•
Confirm that all fan blades move freely.
•
Confirm that no foreign objects obstruct the air paths.
•
Install the panels with the duct collars using the screws from the original
panels or grilles. Handle the gaskets with care.
•
Pull the outer plastic wrapping and insulation away from the end of the duct
to expose the reinforced duct liner.
•
Connect the flexible duct by inserting the exposed portion into the duct collar.
•
Clamp the tie straps around the inside liner. Fasten the duct to the duct collar.