CellarMate Wine Cellar Climate Control, Инструкция по установке, эксплуатации и обслуживанию

Страница: 24 / 42

CellarMate Manual Page 19
Maintenance
General Maintenance
WARNING
Before performing maintenance on the unit, read the safety information contained within the
safety chapter of the CellarMate Manual.
High voltages are present in the cabinets. Turn all power OFF. Use the Lockout/Tagout
procedure before opening panels.
Maintenance on CellarMate units requires working with high voltage and sheet metal with
sharp edges. Only qualified personnel should perform maintenance. Some tasks require
knowledge of mechanical and electrical procedures. Make sure you are familiar with all
hazards, general safety-related procedures, and safety labels on the unit.
The CellarMate is designed for minimum maintenance. The refrigerant is hermetically
sealed and requires no maintenance. The fans are permanently lubricated and require no
maintenance. Some maintenance may be required if there is dust or dirt in the air stream.
Cleaning the Filters
The evaporator and condenser coils are equipped with reusable, washable air filters. The
filters protect the coils from becoming coated or plugged by dust. Clean the filters based on
the amount of dust or dirt generated in the cellar or basement.
1. Remove the grille or duct collar on the inlet end of the unit.
2. Remove the filter covering the face of the coil
3. Rinse the filter with warm water and shake off excess water.
4. Inspect and clean the face of the coil.
5. Reinstall the filter.
6. Replace the grille or duct collar.
Cleaning the condensate Drain System
The condensate drain system traps dust and dirt. Clean the drain system once a year.
1. Shut off the rocker switch and unplug the unit.
2. Remove the grille or duct on the evaporator inlet.
3. Remove the filter and inspect the drain pan under the coil.
4. If the drain pan is soiled, pour some hot water mixed with liquid bleach along
the length of the pan to flush the dirt down the drain tube.
5. Continue this treatment until the loop in the drain is clean and free of dirt.
6. Reinstall the filter and grille or duct collar.
7. Plug the unit in and restart.