CellarMate Wine Cellar Climate Control, Инструкция по установке, эксплуатации и обслуживанию

Страница: 21 / 42

CellarMate Manual Page 16
WARNING
Do not clamp the tie straps around the outside insulation—
Over time, insulation will compress and loosen.
•
Secure the duct collar panel to the unit using the screws set aside.
WARNING
Non-insulated ducts and surfaces can cause exposed metal surfaces to sweat,
further degradation of the insulation, and a loss of equipment cooling
capacity.
Ductwork
Cold Air to the Wine Cellar
•
Remove the supply air grille or access door panels to install the ductwork
from the CellarMate to the wine cellar.
•
Connect the supply air ductwork from the cellar to the supply air outlets at the
CellarMate unit.
•
Connect the return air ductwork from the cellar to the return air inlet at the
CellarMate unit.
Warm Air to the Condenser
•
Connect ductwork on the condenser to direct heat and sound away from
occupants.
•
Connect ductwork to another space within the basement, a building, or to the
outdoors if the heat being exhausted will raise room temperature.
No Ductwork
The supply and return grilles stay on the unit if no ductwork is used. Additional solid panels
may be required; available from your distributor or CellarMate.