CellarMate Wine Cellar Climate Control, Инструкция по установке, эксплуатации и обслуживанию

Страница: 6 / 42

CellarMate Manual Page 1
Standard Specifications
The CellarMate unit contains,
•
A thermal expansion valve to control the flow of refrigerant into the
evaporator coil.
•
A filter dryer to keep the refrigerant clean and free of contaminants.
•
A sight glass to observe the level of refrigerant.
•
An automatic low pressure switch to prevent low suction pressures and frost
formation on the coil.
•
A manually reset high-pressure switch on the discharge to protect the
compressor from high pressures.
•
Environment-friendly refrigerant, only R-134a.
•
A built-in condensate drain trap--no external trap is required.
The CellarMate meets or exceeds the rated capacities for total BTU/H and CFM at design
cellar conditions and external static pressures. Both the evaporator and condenser fans are
capable of rated CFM against the external static pressure imposed by recommended
ductwork. Both fans are motorized impeller plug fans, statically and dynamically balanced,
with permanently lubricated direct drive motors requiring no maintenance.
All exterior framing of the CellarMate is power coated, 0.063” gauge aluminum to prevent
rust and corrosion. All coils are copper tubes with aluminum fins. The unit uses an external
drain to remove excess moisture and not reintroduce it into the cellar or ambient space.
Removable access panels are provided to facilitate maintenance, duct connections, and
access to wiring components.
The evaporator and the condenser coils have pre-filters on the inlet to prevent dust and dirt
from fouling the coils, reducing capacity. Each unit has at least three discharge outlets on
both the evaporator and condenser coils to facilitate custom installations.
Compressors are rotary, self-lubricating, hermetic reciprocating-type compressors with
internal overload protection and capacitor start. Standard manufacturer’s warranty is one
year. Optional Extended Warranty is five years.
Electric power is supplied by a single cord and plug. All external controls are 24 volt,
supplied from an internal transformer. The 230 volt units are capable of operating at 208 or
240 volt by changing the leads on the control transformer. (See Wiring Diagram)