CellarMate Wine Cellar Climate Control, Инструкция по установке, эксплуатации и обслуживанию

Страница: 19 / 42

CellarMate Manual Page 14
number of hours between filter changes is determined over time for each individual
unit and installation.
Option 04 – The optional heating coil is ON. In addition to cooling, this setting
energizes the evaporator fan when heat or humidity is required.
Option 15 – The automatic switch for the thermostat is ON. This setting
automatically switches the thermostat from the heating mode to the cooling mode.
Only for units ordered with the optional heating coil.
Built-in Time Delays
Time delays are built into the CellarMate to protect the components from damage due
to short cycling. Note the various time delays that are explained in the Installation
and Operating Instructions Guide.
* When the COOL ON indicator is flashing, the unit is waiting for the timer before
starting.
Supply and Return Grills Placement
Place the supply and return registers inside the cellar to create an air flow patter that
maximizes air circulation in the room. Avoid short circulating the air.
•
To avoid collecting dust, do not install the return air registers directly on the
floor.
•
Avoid placing the supply or return grilles where they are blocked by bottles,
boxes, or cases.
•
Avoid placing the supply air grille so it blows directly on the thermostat.
The following installation diagrams are for general ideas only. They are not intended to be
complete, detailed installation drawings. For questions regarding installation, contact your
distributor. If further assistance is required, contact us at 888-564-2932, or email
info@cellarmate.com , or fax your inquiry to 860-672-6347.
Installing the Ductwork
Use ductwork to connect the unit to the supply and return outlets in the wine cellar. Use only
insulated ductwork to minimize cooling loss, prevent sweating, and reduce noise.
Use ductwork on the condenser section to redirect or absorb sound, bring conditioned air to
the unit inlet, and to exhaust hot air out of the ambient space. Follow the recommendations
and warnings for duct installation.
Note:
DO NOT EXCEED A TOTAL OF 25’ FOR EACH LENGTH OF DUCTWORK RUN.