5
Setting Up Your Microscope
1.
Take the Styrofoam container out of the cardboard carton.
2.
Remove the tape from the Styrofoam container holding the two sections together.
3.
Carefully remove the microscope and other parts from the container and set them on a table, desk, or other flat
surface.
4.
Remove the plastic bag covering the microscope.
5.
Remove the plastic caps from the eyepiece holders (17) on the binocular head.
6.
Insert the two 10x eyepieces in the eyepiece holders (17). They are held in place by a friction fit.
7.
Remove the four objective lenses (3) from their containers. Unscrew the container lids from the threaded portion
of the objective lenses.
8.
Thread the end of the 4mm objective lens into one of the holes on the nosepiece (2) until finger tight. It may be
necessary to lower the stage (4) by turning the coarse focus knob (7).
9.
Now turn the nosepiece to the next opening and thread each of the remaining objective lenses
into the remaining holes.
Figure 1a
10.
Plug the small cable from the AC adapter into the socket on the back of the base (see Figure 1a).
11.
Insert the plug end of the AC adapter into the proper power source.
Make sure you have the
correct AC
adapter – some models are 115-volt AC and other models are 230-volt AC
You are now ready to use your microscope!
Microscope Operation
Rotating the Head
The head of your microscope can be rotated 360°. Therefore you can view from any position by just moving the head
(1) to the desired location. Loosen the locking screw (10) located between the head (1) and the nosepiece (2) on the
arm (11). Then, rotate the head (1) to the desired viewing location and then tighten the locking screw (10).
Socket
AC Adapter
Содержание Professional 44108
Страница 61: ......