3.1. ASSEMBLING
The ADA-14110 case is adapted to assembly on TS-35 (DIN35) rail. To install converter should mount device on the rail upper part of
the case then press bottom part to to hearing characteristic „Click” sound.
Attention!!
Do not install Wi-Fi devices at a distance of less than 20cm from each other.
3.2. CONNECTION TO WI-FI WIRELESS NETWORK (WLAN)
Connection of the ADA-14110 to WI-FI wireless network (WLAN) can be done by the use of a devices like ACCESS-POINT, ROUTER
Wi-Fi or directly to computer, equipped with Wi-Fi card or other ADA-14110 port server.
In the connector of Wi-Fi interface of the serial server are two diodes (fig.2):
–
ACT green, signalling the state of data transferring or receiving,
–
LINK orange, signalling the active network connection.
Wireless Serial Server ADA-14110 can be use like :
–
virtual serial port [RealPort],
–
TCP serial bridge,
–
UDP serial bridge,
The factory default settings of the ADA-14110 is:
–
to connect to any free wireless network Wi-Fi. Therefore should be set the lowest, free channel of wireless transmission in the
setting of devices like ACCESS-POINT, ROUTER Wi-Fi, Wi-Fi card.
–
to downloading the IP address from DHCP server. Therefore if there is not the DHCP server, to change IP address should be used
ADAFinder software (see p.5.1).
Details of the connection to wireless network will be described in the bellow chapters.
3.2.1. CONNECTION OF THE WIRELESS SERIAL SERVER TO COMPUTER BY THE USE OF
WIRELESS NETWORK ADAPTER
If there is not Access-POINT or Wi-Fi Router, the ADA-14110 can be connected directly to computer by the use of wireless network
adapter as on the figure below. Recommended network adapters USB to Wi-Fi:
–
PENTAGRAM HORNET P6132-30,
–
PENTAGRAM HORNET P6132-08,
–
or other, operating in mode:
Client Wi-Fi
or
Access Point (AP).
For configuration of the ADA-14110 wireless serial server, set wireless network adapter in the
Access Point
mode and make the
configuration as below:
–
SSID adapter name: no name,
–
channel: 1,
–
authentication: non,
–
encryption: non.
Power the ADA-14110 and when will connect to wireless network adapter run the ADAFinder software and make the initial
configuration according to pt.
5.1. INITIAL CONFIGURATION USING ADAFINDER SOFTWARE
.
Fig. 4. Connection AD-HOC type between ADA-14110 and PC
3.2.2. CONNECTION TO COMPUTER VIA NETWORK DEVICES ACCESS-POINT TYPE, ROUTER
WI-FI
Figure below shows correct connection of the ADA-14110 to wireless network WLAN\LAN, by the use ACCESS-POINT, ROUTER Wi-
Fi. This type of connection allows the Wireless Serial Server functioning with PC in virtual serial port mode (RealPort) or TCP/UDP
sockets.
7
ADA-14110
PC with Wi-Fi adapter
ADA-14110
Wi-Fi (802.11b/g) connection,
„Ad-Hoc” type
