7. FACTORY DEFAULT
Parameter
Value
User name
root
Password
dbps
Wi-Fi Setting
IP address
Obtain an IP address automatically using DHCP
Network name (SSID)
No name
Type of connection to network
Connect to any available Wi-Fi network
Network Security
Open System
Serial Port
Profile port
RealPort/<unasigned>
Baud rate [bits/sec]
9600
Number of data bits
8
Parity Control
Non
Number of stop bits
1
Flow Control
Non
8. TROUBLESHOOTING
Problem
Solution
I forgot the password
Restoring Default Settings according to steps below:
1. Power OFF the ADA-14110,
2. Remove the cover of Wi-Fi connector,
3. Press RESET “RST” and holding the button turn the power ON,
4. Release the button after 20 sec. when the ADA-14110 will start with default settings.
Restoring Default Settings deletes existing configuration and the proper configuration should be
loaded to the converter form the backup.
I changed the configuration and
the wireless serial server isn't
functioning.
1. Enter in the Internet browser
http://address-ip-
server,
2. Select the menu
[Factory Default Settings]
press
[Restore]
.
The Serial Server cannot be
found in the Network.
I. If IP address is not known or cannot be found by the use of ADAFinder software and yellow LED is
blinking with high frequency (signaling of network searching), restore Default Settings according to
steps below:
1. Power OFF the ADA-14110,
2. Remove the cover of Serial Server Wi-Fi connector,
3. Press RESET “RST” and holding the button turn the power on of ADA-14110,
4. Release the button and after 20 sec. the Serial Server will start with Default Settings (sec.7),
5. Wait about 1 min. and run ADAFinder for network searching.
II. If IP address is not known or cannot be found by the use of ADAFinder software and yellow LED
continuously lit (signaling establishing a connection between ADA-14110 and Access Point), follow
the steps below:
1.Power OFF the ADA-14110,
2. Set in the configuration of device like ACCESS-POINT, ROUTER Wi-Fi, Wi-Fi adapter, the lowest
free channel of wireless transmission – because ADA-14110 is connecting to any wireless network
during start.
3. Disable Firewall.
4. Turn the power on of ADA-14110.
5. Wait about 1 min. and run ADAFinder for network searching.
III. If IP address is not known or cannot be found by the use of ADAFinder software and yellow LED
is blinking with low frequency (signaling operation in 'ad-hoc' mode), follow the steps below:
1. Power OFF the ADA-14110,
2. Set in the configuration of device like ACCESS-POINT, ROUTER Wi-Fi, Wi-Fi adapter, the lowest
free channel of wireless transmission – because ADA-14110 is connecting to any wireless network
during start,
3. Disable Firewall.
4. Turn the power on of ADA-14110.
5. Wait about 1 min. and run ADAFinder for network searching.
30
ADA-14110
