CEASE FIRE CFX-Plus Pro-Sense 12, Инструкция по установке, пусконаладке и эксплуатации, Страница: 45 / 72

43
CFX-Plus Pro-Sense 8-12 Installation, Commissioning & Operating Manual Approved Document Ref: UI-CFX-Plus-PS-02 Issue 1.0
SETUP & PROGRAMMING
Conventional Sounder Circuit Responses to Selected Zones
Each of the conventional sounder circuits on the main circuit board and high spec zone extension cards
can be independently programmed to respond in one of three different ways for each zone, ON, OFF or
PULSING.
Enter the above code and press the ENTER button.
The zone 1 fire LED will light. This indicates setting how each of the
sounder circuits are to respond for zone 1.
The amber, fault LEDs will show the current sounder circuit settings for
that zone. See table below
Disable
Mode
Test
Mode
Use button 1 to move to the zone that requires editing.
With the required zone for editing LED lit, press the ENTER
button to enter ‘editing mode’.
Test
Mode
Mute
Buzzer
Test
Lamps
The fire zone 1 LED will now pulse to indicate setting the response of the first sounder circuit (SNDR1 on
main circuit board) for the selected zone.
Use button 1 to scroll to the sounder circuit that requires editing, indicated by a pulsing fire LED 1 - 6 as
per table below.
The setting of the sounder circuit is indicated by the amber, fault LED, ON, OFF or PULSING.
LED 1 LED 2 LED 3 LED 4 LED 5 LED 6
SNDR1 SNDR2 SNDR A. SNDR B. SNDR A. SNDR B.
(Main (Main Zone ext. card Zone ext. card Zone ext. card Zone ext. card
PCB) PCB) 1 (Zones 5 1 (Zones 5 2 (Zones 9 - 2 (Zones 9 -
- 8) - 8) 12) 12)
Use button 2 to change the response of the sounder circuit for the
selected zone, ON, OFF or PULSING, indicated by the amber, fault
LED, then use button 1 to move to the next output if required.
Tip - You can use button 4 to change the response of all sounder
circuits simultaneously to ON, OFF or PULSING (for faster
programming).
Mute
Buzzer
Test
Lamps
Press the ENTER button to return back to the zone selection, indicated
by a steady zone fire LED
Disable
Mode
Test
Mode
When finished, press and hold Button 1 for 3 seconds to save setting and exit programming mode
Enter the next programming code or disable the controls and return DIL switch 3 to ‘OFF’.
2
4 3 4 2
RESOUND SILENCE RESET
1
3
Mute
Buzzer
4
Test
Lamps
ENTER
RESOUND SILENCE RESET
1
Disable
Mode
2 3 4
ENTER
RESOUND SILENCE RESET
1 2 3
Mute
Buzzer
4
Test
Lamps
ENTER
RESOUND SILENCE RESET
1 2
Disable Test
Mode Mode
3 4
ENTER