EN
EN
DIGIWAY Plus
Inward or Outward Door Operator
13
The Articulated Arm is designed for push applications, outward opening
The Articulated Arm is designed for push applications, outward opening
doors.
doors.
1) Using the dimensions of the motor and the template provided (see inside of the
1) Using the dimensions of the motor and the template provided (see inside of the
box sleeve) locate the fixing positions and cable holes;
box sleeve) locate the fixing positions and cable holes;
2) Make sure the articulated arm bracket fall in the corrst psoition referring to the
2) Make sure the articulated arm bracket fall in the corrst psoition referring to the
lower diagram on page 12;
lower diagram on page 12;
3) Make 6 holes diameter Ø 8 mm and insert the 6 rawl plugs provided;
3) Make 6 holes diameter Ø 8 mm and insert the 6 rawl plugs provided;
4) Fix the plate to the wall using the screws provided;
4) Fix the plate to the wall using the screws provided;
5) Fix the motor to the mounting plate with the M6 x 14 bolts provided;
5) Fix the motor to the mounting plate with the M6 x 14 bolts provided;
6) Secure the articulated arm bracket to the door reffering to distance A of the table
6) Secure the articulated arm bracket to the door reffering to distance A of the table
above;
above;
7) Attach the articulated arm to the drive shaft using the M6 fixing bolt provided;
7) Attach the articulated arm to the drive shaft using the M6 fixing bolt provided;
8) If distance L3 is larger (see above) an optional extension shaft can be used,
8) If distance L3 is larger (see above) an optional extension shaft can be used,
available in 30mm, 55mm and 80mm;
available in 30mm, 55mm and 80mm;
9) Optional extension shaft: Fix the arm to the drive shaft using the M6 bolt provided
9) Optional extension shaft: Fix the arm to the drive shaft using the M6 bolt provided
with the extension;
with the extension;
10) Check full free movement whilst in free mode;
10) Check full free movement whilst in free mode;
11) Make all electrical connections;
11) Make all electrical connections;
12) Apply power;
12) Apply power;
13)
13) Follow the “Getting Started” procedure
Follow the “Getting Started” procedure;;
14) Connect the Ground wire to the cover terminal and fix the cover.
14) Connect the Ground wire to the cover terminal and fix the cover.
Connect the equipment to the Mains power using the appropriate cable (3 x 1,5mm
Connect the equipment to the Mains power using the appropriate cable (3 x 1,5mm
22
),
),
passing it through the rear opening of the profifile and the backplate and avoiding being
passing it through the rear opening of the profifile and the backplate and avoiding being
too tight and touching sharp edges. At the end of the installation, connect the ground
too tight and touching sharp edges. At the end of the installation, connect the ground
(earth) cable provided from the control PCB to the push on connector on the cover.
(earth) cable provided from the control PCB to the push on connector on the cover.
Parameter
Speed
Power
Description
(mm)
(mm)
A
A
410
410
430
430
Door hinge – door bracket distance
Door hinge – door bracket distance
B
B
270
270
360
360
Door hinge – motor axis distance
Door hinge – motor axis distance
A - B
A - B
140
140
70
70
Motor axis – door bracket distance
Motor axis – door bracket distance
C
C
40
40
Bracket holes distance
Bracket holes distance
L1
L1
55 - 195
55 - 195
Door jamb width
Door jamb width
L2
L2
371
371
Distance wall - articulation
Distance wall - articulation
L3
L3
43
43
Distance motor shaft-door bracket
Distance motor shaft-door bracket
