EN
EN
DIGIWAY Plus
Inward or Outward Door Operator
31
MENU MAIN
SERVICE
SERVICE
COUNTER
SERVICE
THRESHOLD
SERVICE
CHANGE PASSWORD
SERVICE
RESET COUNTER
COUNTER
0
PASSWORD
1111
THRESHOLD
0500
PASSWORD
1111
CONFIRM SERVICE
RESET COUNTER?
PASSWORD
1111
NEW PASSWORD
0000
CONF PASSWORD
0000
NOTES
NOTES
(1) Partial counter value;
(1) Partial counter value;
(2) Threshold : is the number of cycles after which the unit starts to give the Service
(2) Threshold : is the number of cycles after which the unit starts to give the Service
Request message: the main LED flashes RED SLOWLY. Setting this requires entering the
Request message: the main LED flashes RED SLOWLY. Setting this requires entering the
correct 4-digit System Password. If Threshold=0 (factory setting) the main LED never
correct 4-digit System Password. If Threshold=0 (factory setting) the main LED never
changes colour.
changes colour.
(3) Resets the partial counter value: it has to be reset after the maintenance intervention
(3) Resets the partial counter value: it has to be reset after the maintenance intervention
and resets the main LED to solid GREEN.
and resets the main LED to solid GREEN.
This requires the 4-digit system password to be entered.
This requires the 4-digit system password to be entered.
(4) Changing the system password: FACTORY VALUE = 1111
(4) Changing the system password: FACTORY VALUE = 1111
To change the password requires the default or current password to be entered. When
To change the password requires the default or current password to be entered. When
changing the password, the new password must re-entered to confirm.
changing the password, the new password must re-entered to confirm.
(1)
(1)
(2)
(2)
(3)
(3)
(4)
(4)
Information
Information
Information
Display
Display
Expert / Normal
You can change the information displayed on the
You can change the information displayed on the
LCD by setting the operating mode EXPERT or
LCD by setting the operating mode EXPERT or
NORMAL
NORMAL
In EXPERT mode all the main parameters of the motion will be displayed according to
In EXPERT mode all the main parameters of the motion will be displayed according to
the following diagram (see next page):
the following diagram (see next page):
Information
SW Release
WadoPlus v2.0a
dd/mm/yyyy
Gives the SW release number and date.
Gives the SW release number and date.
Information
Counter
Counter
00000
The absolute counter logs each cycle of the door
The absolute counter logs each cycle of the door
(O CLOSING). Its value can be reset by
(O CLOSING). Its value can be reset by
the factory only.
the factory only.
