of Adapter/BS-PS, the system will dial out and
sound the internal siren of the unit & external
Sirens if connected, in ARMED as well as
DISARMED condition.
Press # + Quick Exit
Note:
When the cell of FSW goes low & the system is in ARMED condition, it will dial the pre-fed Telephone number to
inform the user with a Voice Message “Battery is Low + ID Number”. The user can Disarm the system. When a
new Cell is restored in the Sensor, the system registers that the sensor is now operative.
In case system is in DISARMED condition, the display would give a message and the display back light keeps
getting ON for 10 secs and then OFF for 10 secs. During this condition, the system would also give a mild beep
every 15 secs.
.
Signal Repeater
– Wireless
.
Put the Signal Repeater ON by sliding the Slide Switch on the TOP of the Signal Repeater. The Green LED marked as
“Power” will turn ON.
The Switch has 3 positions: Right position is for OFF. The middle & Left position are for ON and are same.
The Display will show digits 0 to 9 one by one and then the Display will turn OFF.
Now register the Signal Repeater in the Main Unit as described below:
Press “
SENSOR
”
Enter Master Password (1234) + #
Press 1
Keep Pressing 2 to select “Tamper”
Press #
Enter 2 Digit ID number (from 01 to 75)
Press #
Remove Magnet Unit of the Signal Repeater (In order to send Tamper signal)
(The Main Unit will give a double Beep indicating that the registration is complete. 5 short beams would
mean that the registration is not successful)
Press Quick Exit
Note:
Number of Signal Repeaters can be registered and used for extending the range from one Signal Repeater to
another.
:
Every Signal Repeater consumes one of the 75 Wireless Sensors capacity of the system.
:
SW and FSW do not work through Signal Repeaters.
Deletion
This process deletes all the Signal Repeaters & Wireless Remotes connected to the system. If only one is to be
deleted then delete all the Remotes/Signal Repeaters and register the required ones again.
Press “
SENSOR
”
Enter Master Password (1234) + #
Press 2 + 2
Press Up or DOWN Key to select the Sensor ID that is to be deleted.
Press Back Space
Press # + Quick Exit
.
Signal Strength test of GSM
.
User can check the strength of GSM signals received at the location where the system is installed. This helps in
locating suitable place of installation.
The system cannot be ARMED when the signal strength is less than level 15
. In that case the display will show “No
Network” or “Network Error”.
If Signal strength is between Level 15 and 18, system will dial out & also send SMS in case of intrusion but may accept
all DTMF digits dialed by the user. Above level 18, the system would work perfect for all features.
Procedure
:
Press “5” Key
Enter Master Password (1234) + #
The display will show the following:
+CSQ
:
X,0
Where X= Signal Strength 0 to 31.
Press “Quick Exit” to Exit.
.
SMS Text & Android Application for Various Programming
.
Programming by SMS:
Following are the SMS Text message that need to be sent to the SIM installed in the system for various actions
:
Action
Command
Description
1 Arm system
XXXX+ARM
The system will be ARMED
2 Disarm system
XXXX+DISARM
The system will be DISARMED
3 Bypass Arm system
XXXX+BYPASS
The system will be ARMED in BYPASS mode
4 System details - Short
XXXX+SYSTEM
System will send SMS giving following details
:
System Status
:
ARMED or DISARMED
Power
:
On Mains / On Battery
