Ringing time of an incoming call, after which the system picks up the call for remote Monitoring (Default = 6 Rings)
Telephone Numbers = Clean.
Time delay to ARM (Default = 00)
Auto ARM/ DISARM (Default = Manual) OFF
Procedure: Press BACK SPACE + Enter Master Password (1234) + # 11 # #
(2 Beeps will indicate that the system has been reset)
.
Resetting SIM
.
In case System doesn’t get ARMED and shows “No Network” then reset the SIM using the following procedure.
Procedure: Press BACK SPACE + Enter Master Password (1234) + # + 1 + 2
(2 Beeps will indicate that the SIM has been reset)
SIM Alarm Enable / Disable
.
The system has a feature to display ‘SIM Absent’ when no SIM card is inserted.
This feature can be Enabled or Disable from the Keypad.
Programming:
Press
“
SET”
Enter Master Password (1234) + #
Keep Pressing 2 to select “SIM Alarm”
Pre
ss ‘Mode’ key to select ‘Enable/ Disable’
Press # + Quick Exit
.
SIM Balance Checking
.
From Main Panel
To know the balance amount in a prepaid SIM card installed in the BAS, following is the procedure
:
Press 0 # - Enter the Balance Enquiry Codes of Service Provider (*123# in case of Airtel)
– Press #.
Balance amount will be displayed.
Press “Quick Exit” to exit.
Through SMS
Registered Mobile Numbers can send following SMS to the SIM installed in the BAS and get reply of the SIM balance
:
SIMBAL CCCCC . . .
Where, CCCCC . . . . . = The Code to check SIM balance (given by the service provider)
Example:
In case of AIRTEL, SIMBAL
123#
.
Siren Hooting time
.
This is the time for which the Siren will keep hooting during intrusion.
If the time is kept = 00 then Siren will not sound at all and the system will silently dial out on telephone line.
Programming
:
Press “
SET”
Enter Master Password (1234) + #
Keep Pressing 2 to select “Siren Time”
Press #
Press 00 to 99 + # + Quick Exit
Where, 00 to 99 = Hooting Time in Minutes of the Siren
Note
:
When the Siren Hooting Time= 00, the “Srn” display on the right hand side corner of the Main Unit LCD Display
will not be there.
:
The default value is 30 Minutes.
.
Siren ON or OFF
.
The Siren of the system can be disabled. Then the siren will not sound in case of intrusion however Telephone dialing
shall be done by the system, if enabled and telephone numbers are entered.
Siren cannot be disabled for the following conditions:
When any of the Wired Zone or wireless Sensor is open & system is being Armed.
Programming:
Press “
SET”
Enter Master Password (1234) + #
Keep Pressing 2 to
select “Siren ON/OFF”
Press #
Press Key “UP” or DOWN” to select ON / OFF
Press # + Quick Exit
Note
:
In default it is = ON
.
Siren Wireless or Flashing Siren-Wireless (FSW) Registering
.
Press “SENSOR” key
Enter Master Password (1234) + #
Press 1
Keep Pressing 8
to select “Flashing Sir
n
”
Press #
