1
2
3
STERN PANEL
43
1)
2)
3)
FUNCTIONS
SET-UP AND FUNCTIONING OF THE ALARM-CLOCK
Doglight switch, it depends on the main switch
Pushbutton for the setting of the alarm-clock; it is used to shift between hours and minutes setting.
Pushbutton for the activation and deactivation of the alarm clock and for the setting of the alarm-clock
time.
The current time, external temperature and burglar device and gas detectors alarms are displayed:
- GAS ALARM
.
When one of the alarms turns on, the relevant message is displayed until the reason of alarm is
eliminated.
It's on only when the contol panel is on in stand-by mode.
The watch is controlled to the control panel.
To start the setting of the alarm-clock push the button ref. 2 for about 2 secs; hours’ digits are blinking
on the display.
The button ref. 3 allows to set the digits.
Pushing again the button ref. 2, you can shift to the minutes setting; minutes’ digits are blinking on
the display.
A third pressure on the button ref. 2 saves the set-up.
After the set-up it is necessary to activate the alarm pushing the button ref. 3 for about 2 secs.
The alarm remains active until deactivated by pushing the button ref. 3.
The symbol
on the display shows that the alarm is active.
As the selected time is reached and the alarm is active, the alarm clock starts beeping for 1 minute or
until a button (ref. 2 or 3) is pushed.
- LEFT locker forced ALM LKR L/H (OPTIONAL)
- RIGHT and/or rear locker forced ALM LKR R/H-BK (OPTIONAL)
- Van's door forced ALM DOOR OPEN (OPTIONAL)
- Volumetric sensors alarm when the burglar device is activated "ALM VOLUMETRIC"
(OPTIONAL)
%
“
“
“
“
“
“
“
“
EN
G
LI
S
H
