iv
BC0154501-00 P
User’s Guide—Converged Network Adapters and Intelligent Ethernet Adapters
FastLinQ 45000 Series
Updated the following iWARP procedures:
In
To enable iWARP on the
Windows host and verify RDMA
procedure,
changed the parameter to
NetworkDirect
Technology
(was
RDMA Mode
).
In
of the
To verify iWARP traffic
pro-
cedure, changed the command to
netstat
-xan
(was
net -xan
).
“Configuring iWARP on Windows” on page 169
In the
To configure the NFS server
procedure:
Added a new
that describes how to
create an
nfs-server
directory and grant
permission.
Replaced
for loading the service.
“Configuring NFS-RDMA” on page 175
In the
To configure the NFS client
procedure:
Added a new
that describes how to
create an
nfs-client
directory and grant
permission.
In
, updated the command used for NFS
Version 4.
“Configuring NFS-RDMA” on page 175
Following
, added a fourth bullet to the
note: “Switch dependent teaming (IEEE 802.3ad
LACP and Generic/Static Link Aggregation (Trunk-
ing) cannot use a switch independent partitioned
virtual adapter. IEEE standards require Switch
Dependent Teaming (IEEE 802.3ad LACP and
Generic/Static Link Aggregation (Trunking)) mode
to work per the entire port instead of just the MAC
address (fraction of a port) granularity.”
“Configuring Microsoft Initiator to Use Cavium’s
iSCSI Offload” on page 197
Added new section addressing an issue with iSCSI
offload on RHEL 7.6.
In the note, added the following: “For NDKPI
Mode-2, you must enable Network Direct Function-
ality of the physical interface.”
